Stainless steel star discharger

The stainless steel star discharger,also known as the stainless steel feeder and stainless steel ash discharge valve,is the main equipment for ash discharge in the storage,feeding,quantitative feeding,air flow conveying and dust removal equipment system of powder engineering.It is suitable for powder and granular materials and is widely used in environmental protection,metallurgy,chemical industry,grain,food,and other industrial sectors.The stainless steel discharger is made of(304,321,316L,310S).It is not only,but also,when the application occasion requires zero protection function,the end of the stainless steel discharger can be conveniently configured with a sensor to achieve online monitoring and on-site monitoring.The stainless steel discharger can play and exert its best efficiency in the food,chemical and pharmaceutical industries.

Features of stainless steel star discharger:

(1)By adopting the principle of planetary rotation,the input and output shafts are on the same axis,and it has the property of being directly connected to the motor,so it has a compact structure,beautiful and novel shape,small size and light weight.

(2)The stainless steel star discharger runs smoothly,has low noise,low failure rate and long life,and the gearing is made of bearing steel.Use powerful and high.

(3)Bearings and gearboxes should be kept away from the valve body to avoid the influence of high temperature and dust.The front and rear cover seals should be strong to prevent dust leakage and extend the service life of the machine parts and lubrication system.

(4)This machine has overload and strong inertia torque,which is suitable for frequent starting and reverse rotation.

(5)If the user needs specifications,hydraulic,sprocket drive and other unloaders,please contact our factory and we can make them.

Use and maintenance of stainless steel star unloader:

(1)This machine is suitable for continuous working system and allows forward and reverse operation.

(2)When the output shaft and input shaft are matched with other parts,direct hammering is not allowed to prevent damage.

(3)During transportation and installation,it should be kept stable and avoid collision,which may cause the shell to break or deform.

(4)After the machine is put into use,the transmission and bearing parts should be refilled with oil(lithium-based grease)within 6-10 months.If the ambient temperature is high,humid or there is too much dust in the air,the oil change time should be appropriately shortened.

(5)During use,if the equipment leaks air or ash along the axial direction,tighten the screws of the pressure cover or replace the packing and then tighten the pressure cover.

(6)During operation,avoid damage to the reduction motor due to equipment jamming or motor short circuit caused by excessive material or overload.It is recommended that users install an overload protection device.